Currency Displayed in
For independent switching of two loads via make contacts. The actuator has integrated current detection that measures the load current on each channel. All 230 V switch outputs can be operated with manual switches. With integrated bus coupling unit.
For installation on DIN rails EN 50022. The bus is connected using a bus connecting terminal; a data rail is not necessary. A green LED indicates that the device is ready for operation once the application has been loaded. The load is connected with screw terminals.
- Operation as break contact or make contact
- Staircase lighting function with/without manual OFF function and switch off warning
- Delay functions
- Scenes
- Logic function
- Blocking or priority control
- Feedback function
- Status
- Central function with delay
- Parameterisation for bus voltage failure and recovery
- Behaviour for download
- Current detection function: Behaviour when value exceeds/falls short of the threshold value. Energy, operating and switch on counter with limit value monitoring
- Flash function
BUS type: | KNX |
Number of contacts: | 2 |
Total number of 18 mm modules: | 2.5 |
Mounting support: | DIN rail |
[Ue] Rated operational voltage: | 100...240 V |
Network frequency: | 50/60 Hz |
[In] Rated current: | 0.1...16 A |
Load type: | Parallel compensated fluorescent lamp : <= 1086 VA, 100 V AC Parallel compensated fluorescent lamp : <= 2500 VA, 230 V AC Parallel compensated fluorescent lamp : <= 2608 VA, 240 V AC Incandescent lamps : <= 1600 W, 100 V AC Incandescent lamps : <= 3600 W, 230 V AC Incandescent lamps : <= 3840 W, 240 V AC Halogen lamps : <= 1086 W, 100 V AC Halogen lamps : <= 2500 W, 230 V AC Halogen lamps : <= 2608 W, 240 V AC Capacitive : 16 A - 200 µF, 100...240 V AC Motor : <= 434 W, 100 V AC Motor : <= 1000 W, 230 V AC Motor : <= 1043 W, 240 V AC |
IP degree of protection: | IP20 |